i just had my struts and lower control arms replaced, and my abs light came on after along with check engine, traction control, blinking brake and cruise control lights. i got the codes read and it said it was the left wheel speed sensor. to test it, i swaped the two front ones and had the codes read again, and it then said it was the right wheel speed sensor (P0500, C0057, C0022) so i’m pretty certain that that sensor was the issue. i replaced that sensor and disconnected the battery for a while, but the lights are still on. so my question is, does the new sensor need to be calibrated or something with a special scanner or computer? or can i reset it myself? i also had a wheel allignment done during this, so not sure if that would mess with anything. thanks!
